Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2023 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Stalling and OBD question 900 1995

posted by  guri r on  Sat Apr 2 03:46 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 8 22:46 CST 2014
[RELATED]

Good morning. The car is a 1995 945FT. Last night, after an abrupt stop at an intersection, our car stalled. It started right up again and we drove home. But, when we got there, I tried to start it right up again just to check, and it had a hard time getting started again. Took several protracted cranks. So, I went out this morning and checked a couple of things. It started right up, but I found following:

1. Charging system looks OK for voltages at alternator and battery, although I did get a 0.7V drops across both the block and alternator housing and the negative battery terminal. Anything to worry about? Check battery ground?

2. On the OBD, I got 1-1-1 at both sockets 2 and 6. But, it wouldn't go through the erase memory sequence in position 2 and the TPS and speed sensor checks in position 6 as described in FAQs. No response for those. Does this mean that something is wrong with the OBD or all OK? Seemed a bit odd to me so thought I should ask.

Thanks for any feedback.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stalling and OBD question [900][1995]
posted by  guri r subscriber  on Sat Apr 2 03:46 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.