Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Bushing tools 200 1993

posted by  Irollturbo on  Tue Mar 29 09:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 6 14:36 CST 2014
[RELATED]

I have access to a press and would finish up my poly bushing R&R job. The trick seems to be finding the right steel tubes to receive the old pushing when pressed. The front control arm calls for a 1.75" ID steel tube. The rear control arm front calls for a 1.6" ID steel tube.

Anybody have any hints on where I can find this? It is a nonstandard size for steel pipe, so that doesn't look good.

Once I have that, the job should be reasonable given a press.

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bushing tools [200][1993]
posted by  Irollturbo  on Tue Mar 29 09:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.