Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M47 Front and Rear Oil Seal Replacement 200 1987

posted by  Martyn on  Sun Mar 27 10:24 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 22 01:00 CST 2008
[RELATED]

In the process of replacing the clutch in my 240 that has done over 250,000 on the original (not too bad in my book). Notice the rear oil seal on the M47 manual transmission is very wet, obviously about to start leaking. How easy is it to replace this seal? Looks like I will have to remove the rear cover from the transmission before I can withdraw the output shaft and get at the oil seal, don't want too finish up with more of a problem than I start with due to lack of knowledge (Haynes doesn't cover this job...at least in the one I have).
Any thoughts on the value and difficulty on replacing the input shaft oil seal as I have the tranny out, would also be appreciated.
Thanks,
Martyn






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.