Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

D24T Diesel, Valve stem to guide clearance 700

posted by  werick on  Tue Mar 15 05:23 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 6 08:25 CST 2011
[RELATED]

Hi all

I'm into the head now on my diesel rebuild. I'd like to get some advice on Valve Stem to Guide clearance.

The Volvo Green book procedure is to hold the valve open. The stem flush with the end of the guide and measure the side to side clearance with a Dial Indicator. Anything over .0511" is excessive. This seems like alot. I've worked on gassers with much less play than this. I've heard of errors with the Green Book. I'm wondering if this is one?

In any case, I have .042" Exhaust and .023" Intake (Highest reading, but pretty consistant.)

What would you guys do? Leave it alone or replace the guides. I haven't the facilities to press out guides so I'd have to send it out.

I'm leaning towards leaving it alone due to the fact that every valve has a positive Valve Stem seal that is getting replaced.

Thanks again






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New D24T Diesel, Valve stem to guide clearance [700]
posted by  werick  on Tue Mar 15 05:23 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.