Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing a Manifold stud at collector 700

posted by  someone claiming to be Kurt Wolko on  Mon Mar 14 05:45 CST 2005 [RELATED]

Got the 740 back from Morgantown Saturday night. Now I am replacing the front end of the exhaust system.

There was only one stud at the collector when I purchased the car. The other 2 were thru-bolted. I'd like to put new studs in, so I cut off and drilled out the remaining stud, and two out of the three holes still have threads. There is one that had been drilled out some time in the past leaving no threads.

Stud size I think was about 10 mm, from what I measured. I would like to tap the manifold 7/16 and put new studs in. Does anyone know where I might locate a stud that's 7/16 thread on one end, and 3/8 thread on the other? Reason I'm leaning towards English threads is I have an English thread tap and die set. I measured the clearance hole in the head pipe flange and it's about .440, so I thought a 3/8 stud would work fine.

Any input is appreciated.

Thanks,

Kurt






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing a Manifold stud at collector [700]
posted by  someone claiming to be Kurt Wolko  on Mon Mar 14 05:45 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.