Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ignition Wires 200

posted by  Irollturbo on  Mon Feb 28 16:39 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 6 14:36 CST 2014
[RELATED]

I measured the resistance of my ignition wires. These wires are fairly new (18 months) and I am just crawling through things looking for the source of a slightly unsteady idle. Anyway, I measured the following:

Wires for Cylinders 1-3 show ~3.7K ohms
Wire for Cylinder 4 shows ~4.4K ohms

Is this in the realm of reasonableness. #4 is a bit longer, but that 4.4K still caught my eye. If I was doing this right I would have measured the length of each wire and calculated K ohms/inch. But I didn't. Sigh.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition Wires [200]
posted by  Irollturbo  on Mon Feb 28 16:39 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.