Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

SSTEF and B21A drivers 200

posted by  RLC on  Thu Feb 10 03:08 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello all,

A follow up to my B21A JFU4 Distributor Conversion to B21E JGFU4 electronic. It worked well for two weeks, without fail. I actually improved mileage. Yesterday, I needed to make photocopies, 5 minutes away. Should have walked, but it was threatening rain. After I made my photocopies, the car would not start with dynamite! I did the usual checks, Air, Fuel, Spark. I noticed the B21E distributor provided a yellowish piss-weak spark, when I pulled #1 Spark Plug. Usually, when one just pulls the #1 Spark Plug wire it will make a popping sound and spark from the end of the Spark Plug Wire to the Valve Cover. Mine didn't. That's when I decided to check it with the Spark Plug removed.

I had a spare control module, spark plugs, ballast resitor, coil. Nothing seemed to make any difference. Does anyone have any clues. Could the Induction Coil, inside the Distributor cause a weak spark?

Believe it or not, I installed the OEM B21A Coil, Resistor, and Distributor, set at TDC, and it started right up. Unbelievable.

I checked the Ballast Resistor and Coil, against the specs and they seemed ok.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SSTEF and B21A drivers [200]
posted by  RLC  on Thu Feb 10 03:08 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.