Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Broken exhaust stud 700

posted by  crank it on  Sun Jan 30 11:43 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi All

I have a broken exhaust stud (the lower stud rear cylinder) B230f. The stud is broken off just below the surface of the cylinder head. I have read the FAQ and did a archive search. I read that there it would be possible to build up the stud using a Mig welder. Has anyone used this method? If I use flux cored wire what kind of problems would I encounter with the aluminum block? Has anyone tried grinding out the stud with a dremel with the head on? Any other suggestions other than removing the head and taking to a machine shop?
Thanks
Brad






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Broken exhaust stud [700]
posted by  crank it  on Sun Jan 30 11:43 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.