Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Good news, source of coolant leak found, Bad news is........ 900

uid 19's pic
posted by  jbowers on  Thu Dec 16 10:25 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jan 22 13:49 CST 2012
[RELATED]

I have been trying to find the coolant leak on my '96 965 which has dumped about 1 pint a week for the last several months. I could always see a few drops hanging off the suspension brace that runs across at the back of the engine but couldn't see where it was exiting the engine dispite mirrors, feeling for wetness etc.

I finally took it to the dealer who found the leak between the head and block at the back of the engine after leaving the system pressurized for about an hour.

So I'm now going to do a "head job" on my car to replace the head gasket.

I have the tools for aligning the crank/cams and plan to buy the cam seal installation tools for the back. Can anyone tell me if the front cam seals can be installed with "normal" tools?

This will be the time to install those high lift cams from a 204HP engine that I acquired several years ago! This cloud has at least one "silver" lining as the saying goes.
--
'96 965 with 16' wheels at 121K. Had '85 745 Turbo Diesel for 200K.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Good news, source of coolant leak found, Bad news is........ [900]
posted by  jbowers subscriber  on Thu Dec 16 10:25 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.