Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2007 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Strut Rod Bushing Installation Question 900 1995

posted by  matt82dl on  Wed Oct 27 01:20 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 10:46 CST 2014
[RELATED]

I just finished installing the IPD Poly strut rod bushings. After reviewing the the instructions again, (especially the cross-section view) it looks like IPD is indicating that the front and rear washers should be tight against the steel spacer. Does anyone know if this is the case??

Right now I just have them 'good n' tight', but is the proper installation for the spacer to be sandwiched tight between the rear and front washer??

BTW... the bushings did tighen up the front end, but didnt eliminate and vibration / pulsing of the wheel during moderate to heavy braking.

Thanks,

Matt

--
'82 DL - 158k, '93 945 - 116k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Strut Rod Bushing Installation Question [900][1995]
posted by  matt82dl  on Wed Oct 27 01:20 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.