Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

what color is the temp sender wire under the intake manifold? 200 1984

4 cylinder not turbo. What color is the wire supposed to be to the temperature sender under the intake manifold? My insulation is shredded. Where does this wire go? What is the second sensor (brown wire) below it in the block for? My fuel injectors aren't getting any signal and so never open. Car will run on ether, smoothly even with the right amount. Fuel pumps ok, if i take hose off at rail, can pump fuel out hose by normal starting with ig switch. Spark works but maybe weak. I've replaced some other shredded wires between ecm and distributor, rest look ok there. thanks for any help






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New what color is the temp sender wire under the intake manifold? [200][1984]
posted by  joehorton  on Fri Oct 22 15:26 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.