Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1993 945 turbo rpm sensor 700

posted by  R_J on  Tue Oct 12 14:28 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Looking for help with this issue- car would not start- just turned over and over- then a loud grinding noise occured, and then the grinding noise stopped, car still would not start. Fault code 214 intermitent rpm sensor output- took old sensor off, the end was chewed off- pulled small covers from bell houseing and three small parts fell out- two looked similar to roller bearings- parts appeared chewed up slightly-

no damage visable on ring gear or starter drive
replaced sensor with new, car started right up however it is now rough idleing and rpm gauge jumps below 2000 rpm above 2000 it runs smooth.

could the metal parts be from flywheel rpm sensor triggers?

any ideas before I pull tranny??????????






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 945 turbo rpm sensor [700]
posted by  R_J  on Tue Oct 12 14:28 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.