Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Caliper mounting shims 200 1993

posted by  raidman on  Mon Oct 11 14:12 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

Been trying to replace the warped and under-thickness reground Brembos (cross-drilled) front rotors on my 93 245. I bought some ATE vented rotors...too big in diameter..so had a machine shop remove the edge and bring them to 263mm outside diameter (they were 280mm).
Now they are 1mm too far inboard and rub against the inner edge of the caliper. I need a shim that is 0.5mm thick to add between the mounting bolt and the threaded hole in the strut. Where to get these??
Or has any one done a "ShadeTree" replacement? What else would take the pressure and heat? A thin washer? Where to get these?
Bentley lists 0.2 and 0.4mm shims (as neccesary) to center the caliper.
Any ideas?
Gracias,
el Raidman







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.