Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How do I see the Fault Codes? 200 1993

posted by  Ken C on  Sat Oct 9 07:03 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:39 CST 2014
[RELATED]

Hi. This is a '93 240. I'd like to check for any fault codes.
The box (near the brake master cylinder) has the probe wire, the little button, and the LED, along with only two (of the eight) holes in the box with terminals inside -- they're no. 2 and no. 6.
What do I do?
Assuming I'm supposed to put the probe wire in one of them, which one, 2 or 6? Do I do this with the ignition key switch on, or on accessories, or off? When do I press the little button next to the LED? And what's the order of steps.
I also assume that I count the blinks of the LED, but for how long (3 digits?), and supposed there's more than one fault displayed? How do I tell them apart -- do they repeat?
Sorry for all these questions -- please be patient and explain the procedure -- this is my first 240 with this feature.
Thanks very much.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do I see the Fault Codes? [200][1993]
posted by  Ken C subscriber  on Sat Oct 9 07:03 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.