I replaced the dash so everything was disconnected and labled. While the dash was off, I removed the wiper motor and linkage and found why the wiper travel was pretty excessive on the driver side. With some adjustment to the linkage, it all went back together just fine. I pulled the motor cover to see if there was gunk or anything else nasty around the motor and all looked good.
Now that it is all back together, everything works except the wipers. I was pretty careful to lable the wires that were pulled from the motor, not the switch.

Is there anything I could try to track down the problem? The Oregon rainy season is almost here and I would sure hate to keep it in the garage til spring.
DC