Heres the scoop, I inherited a non-running 240 wagon, the engine harness was frayed in many places, I acquired a good used one, installed it, now car will not start. No power at the In-Tank fuse. I tried new relay, no luck, I did the jumper wire trick bypassing the fuel pump relay, both pumps are making noise. Both relays do nothing no clicking or anything. All harness connectors are connected. How do I go about determaning if it is a wiring issue, or a bad ignition switch. As I just replaced the harness I suspect it is a wiring issue, Where should I start. Help save the 240 I'm loosing hope in Minneapolis.Dave-ed
|