Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 beltline trim -- put anything under it? 200

posted by  Gregg Shadduck on  Tue Oct 5 13:06 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 7 12:10 CST 2014
[RELATED]

I'm sorry if this has been asked countless times before, but I don't see it after searching...

Is there any wisdom in putting anything under 240 beltline trim moldings?
I see before me trim with a real collection of dirt, and am imagining winter-time SALT there, too. :-(

Well, I have taken the trim off, and will WAX the area on the car. Yea!

IS there any point in adding, well, in boats it would be called LUTING, in one application, or BEDDING compound -- that is, goopy stuff that, by its presence, keeps out water? I doubt it, since the trim cavity (the backside) is so large and loose, but there are many bright Brickster minds out there! :-)

Thanks!
--
Gregg; Mpls, MN; 1987 745, 1967 Amazon 4-dr.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 beltline trim -- put anything under it? [200]
posted by  Gregg Shadduck subscriber  on Tue Oct 5 13:06 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.