Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How do I press new bushings into front sway bar link ? 200 1993

posted by  Mr. Tool on  Fri Sep 24 04:16 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 1 17:19 CST 2014
[RELATED]

Hi: Have a 1993, 240 wagon. 184,000 miles.

I'm putting in new front rubber bushings on all my front suspension componenets.

QUESTION ? On the link rods that connect the control arm to the front sway bar, how do you press in new rubber bushings? These are the ones that connect the control arm to the bottom of the link.

I have the old ones out, however the new bushings and the link itself is concave/convex in design in the center.

When I attempt to press them into the link the leading part of the bushing will not compress enough to pass by the center portion of the link (at this point the inside diameter of the link is now smaller than the OD of the bushing, because of the concave design). The bushing just start to get squished.

It's almost like you have to compress the rubber of the bushing prior to pressing it into the link.

How do I get these bushings pressed in?

Any help would be appreciated.

Thanks
--
Mr. Tool






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do I press new bushings into front sway bar link ? [200][1993]
posted by  Mr. Tool subscriber  on Fri Sep 24 04:16 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.