Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

oil on the valve cover...question from an apprentice wanna be 200 1987

posted by  girlwagon on  Sun Sep 19 08:01 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I was trying to get rid of a sqeak when I'm in Park and I thought it was the belts being loose or something like that. I noticed that on one side of the valve cover there is nasty dirty oil building up. So I had the 10mm in the ratchet and set them all really tight. A couple of hours later at coffee with a friend He told me I shouldn't have done that tightening. That I could have screwed up my gasket and that I should have a special measuring wrench to do it etc...
Is he right? I'm certainly not a mechanic, Just an apprentice wanna be with this forum as my mentor.
And besides I didn't get rid of the sqeak but my belts are tighter.

Any advice would be appreciated.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New oil on the valve cover...question from an apprentice wanna be [200][1987]
posted by  girlwagon  on Sun Sep 19 08:01 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.