Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I'm stuck with o2 sensor/ check engine light 200 1989

posted by  Mark Lundell on  Tue Sep 7 13:31 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 14 21:34 CST 2014
[RELATED]

My '90 240 was running very poorly. Gas millage dropped dramatically in a short time period. Codes said signal missing from O2 sensor. I just replaced it with a bosch 13913 3 wire (for a ford mustang). It runs a bit better, but then check engine light came back on again. Codes are now 1-1-3 - injector fault, 2-3-1 O2 sensor is not operating, and 2-2-1 O2 sensor not operating. When I check the voltage from the sensor it reads 1.8 volts to 2.0 volts. Can this be right or did I measure it wrong?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I'm stuck with o2 sensor/ check engine light [200][1989]
posted by  Mark Lundell  on Tue Sep 7 13:31 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.