Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Can the ring-gear be offset 45 degrees without removing the transmission ? 700

posted by  ndesouza on  Tue Aug 31 21:26 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 18 15:14 CST 2012
[RELATED]

Hi,

I have a 1985 740 GLE, Non-Turbo sedan with the ZF-22 transmission. I believe my ignition system is the Jetronics 2.2 (so the sensor is embedded in the distributor as opposed to on the bell-housing).

The edge of the gear-teeth on the section of ring-gear that engages with the starter are chewed up. I've changed the starter gear, and would like to also offset the ring-gear by 45 degrees so the worn tooth-edges no longer mess up the starting.

Forgive my ingnorance about this, but is it possible to unbolt the 4 bolts that attach the ring-gear to the engine, rotate it 45 degrees, and rebolt it without removing the tranny ?

Thanks !

Noel






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can the ring-gear be offset 45 degrees without removing the transmission ? [700]
posted by  ndesouza  on Tue Aug 31 21:26 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.