Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

speed sensor casting 200 1989

posted by  baidarka on  Mon May 31 02:18 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Was trying to install a new engine speed sensor yesterday. Old one had probably never been replaced and was really STUCK. The long and short of it is I pried too hard and broke the casting it's mounted in. Looks impossible to replace without dropping the transmission because of the location of the nuts that hold it on. Will cheerfully accept any advice as to: 1) a source for the part, 2) the name of some magical adhesive I could use as at least a temporary fix, and 3) a way to get at those nuts without dropping the trans. Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New speed sensor casting [200][1989]
posted by  baidarka  on Mon May 31 02:18 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.