Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cam position for head reassembly 200 1980

posted by  zrubin on  Wed May 5 09:21 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 20 15:45 CST 2012
[RELATED]

I took the head from my 245DL to a machine shop for resurfacing and a valve job - when I reassemble the head to the engine, how do I set the position of the camshaft to match cylinder #1 TDC? When I removed the timing belt, I marked the belt in 3 places and the 3 corresponding gears, but once the valvetrain is disassembled and reassembled, I'm not sure how the cam gear would end up in the right spot. Hopefully I didn't miss a step...

Thanks

Zack
1980 245DL M46 272k
1988 745T+ M46 191k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cam position for head reassembly [200][1980]
posted by  zrubin  on Wed May 5 09:21 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.