Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Great Idea for remounting grills with broken tabs 200

posted by  nabramson on  Wed Apr 21 16:22 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 20 15:00 CST 2011
[RELATED]

Part of participating in the Brooklyn parking wars is having your front grill pushed in by some big SUV's rear bumper. As a result the lower tab's are broken & The grill falls out because there is no holding in the lower part.This also applies to the Headlight trim Bezels.
I found a solution. I screw Plastic license plate bolts in the lower mounting holes & slots in the front lower body panel with the bolt end facing up. I then file down what is left of the broken grill tabs on the bottom of the grill & then drill a hole that is a little bigger than 1/4 inch where the tab used to be. With the bolt end of the license plate fasteners facing up they go into the new holes & you have a good new mounting for your grill without having to get a new one.
Tomorrow I will do this on the broken part of my left hand headlight Bezel.Just had to pass this on.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Great Idea for remounting grills with broken tabs [200]
posted by  nabramson subscriber  on Wed Apr 21 16:22 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.