Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ordered rear bushings today ... 200

posted by  someone claiming to be bosozoku on  Fri Apr 9 06:16 CST 2004 [RELATED]

from FCP Groton. Poly rear RTAs, poly torque rods (I played with
my car's rods and they felt pretty loose), rubber panhard rod bushes,
and rubber front RTAs - the poly bushes required removing a welded
bracket on the car's body. Total cost: $133 incl. shipping. The poly
bushings are SuperPro and the others are MTC brand, not ScanTech.


I'll still need to buy a set of jackstands and borrow a floor jack
from my neighbor. Should I lube the poly bushings with anything
before I install them, or are they better off dry?


The rear shocks were replaced a year and 1/2 ago by the PO, so I
don't think that I'll need new ones. I might get new ones after
the bushing job is done and when I do swaybars.


If anyone has any other suggestions...


Thanks in advance,
-b.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ordered rear bushings today ... [200]
posted by  someone claiming to be bosozoku  on Fri Apr 9 06:16 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.