Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How to adjust header pipe bracket? 200 1990

posted by  lrisius on  Fri Feb 20 13:15 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Hi,
I changed out my motor and tranny mounts and now am getting some noise from the header pipe hitting the tranny support crossmember. I think the new mounts raised the engine and have pulled it up tight. In a previous post someone had suggested checking the header pipe bracket adjustment. How do I adjust this? I can see the two bolts and they appear to let it slide. Do I just loosen them and pry the header down and re-tighten or is there a better way? I haven't found instructions for this anywhere. It seems to be pretty much neglected in all the discussions about changing the header pipe.

Thanks!
Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to adjust header pipe bracket? [200][1990]
posted by  lrisius  on Fri Feb 20 13:15 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.