Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

86 to 93 WINDSHIELD UPGRADE 200

posted by  Xraybob on  Sun Jan 18 02:23 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

The frame of my 86 sedan is curling at the base of the drivers side and I can't seem to get it to stay down anymore. I've priced the replacement windshield from the 93 with SAFELITE glass company at about $220. They say the windshield comes with the new frame moulding. My question is, I just had the car painted last year and the paint shop masked off to the edge of the rubber gasket of my windshield frame and it was a good mask. Is the width of the new moulding/gasket the same width and what is the chance of the paint peel/chip off when the old gasket is removed. Anyway of preventing this problem if it does exist?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 86 to 93 WINDSHIELD UPGRADE [200]
posted by  Xraybob  on Sun Jan 18 02:23 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.