Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

intake manifold removal 200

posted by  someone claiming to be jerrjl on  Thu Jul 31 02:17 CST 2003 [RELATED]

i was try to remove the intake manifold to replace the gasket, but i found some of the bolts holding it in place are difficult to get to. is there any special tool required to perform the job? this is also true for one of the bolt holding down throttle body(the one near to the throttle position sensor).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New intake manifold removal [200]
posted by  someone claiming to be jerrjl  on Thu Jul 31 02:17 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.