Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How do I replace the clamp that holds the cat to the rest of the exhaust? 200 1982

posted by  82silver240turbo on  Tue Jul 29 11:53 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 11 05:37 CST 2013
[RELATED]

In an attempt to make the removal of my catalytic converter easier I chose to hacksaw the bolts that tighten the clamp that holds the cat to the rest of the exhaust system. Now it seems the bolts are part of the clamp, or at least are now after years of exposure. I am not sure if the cut ends of the bolts can be removed from the clamp, so I am wondering if the clamp itself can be removed and replaced or if it is a standard piece of the exhuast that comes as part of the pipe. Anyway, I was wondering if anyone could give me any advice on what I could or should do?
Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How do I replace the clamp that holds the cat to the rest of the exhaust? [200][1982]
posted by  82silver240turbo  on Tue Jul 29 11:53 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.