Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How is the Heater Fan switch supposed to be wired with the AC? 200 1980

uid 15053's pic
posted by  Dylan Berichon on  Mon Jul 21 13:48 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 17:22 CST 2014
[RELATED]

Back in November, I replaced the heater fan in the '80 245. At the time, I didn't fully wire up the AC components, because the AC doesn't work on the car. With summer here, however, I've been thinking about getting it working again, so I have a couple of questions on how to hook it up...

The instructions from IPD (which I loosely followed) told me to connect a wire from pin #5 on the new switch to the hot side of the Thermostat Switch. Is the Thermostat Switch that rotating AC switch? If so, how do I tell what side is hot? (I use to know how, but I can't remember.

The next step told me to connect the white wire from terminal #86 on the AC relay to the wire in pin #6 in the new switch. Where is the AC relay?

Thanks everyone. Next, I'll be asking how to test the compressor.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.