Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

crank shaft bolt, camshaft bolt, etc. torquing.

posted by  Pilicer on  Wed May 28 16:39 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 26 22:52 CST 2013
[RELATED]

I noticed im my Volvo service manual TP 30518/9 That the "Tightening torque data" stated, "The tightening torques apply to oiled nuts and bolts. Degreased (washed) parts must be oiled prior to use.
exs. camshaft gear......37 ftlb
crankshaft, center bolt pulley, step 1.....43 lb
step 2.....angle-tighten 60 degrees
I wonder if the faq should add this if its correct, or if not tell me what is :) Had I not been reading my newly acquired green books I would have torqued them dry.
Thanks,
Bill






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.