Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Sound barrier door seals. 200 1986

Hi all -

My wifemobile (1988 244GL) has a sort of extra seal on the upper half of each door. The parts guys at the dealer told me that (1) it's to cut down on wind noise and (2) it cannot be retro fitted to earlier model 240s.

Well, I managed to get a set from a recycle yard, and I want to install them on my 1986 244GL. I have some 1/2 inch wide foambacked double stick tape which should fit OK even though I think Volvo uses 12mm wide. The tape is from Ace Hardware, should I find some that's made for automotive exterior use?

My main question is this: What should I used to get the area where the tape will be stuck on to be really super-duper clean? Denatured alcohol? 409? Simple Green? 000 steel wool? Your contributions will be welcomed.

Thanks in Advance,

Bob

:>)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sound barrier door seals. [200][1986]
posted by  B.C. subscriber  on Thu May 1 19:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.