Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2024 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Scan Tech HD wagon springs 900 1993

posted by  Brian S on  Tue Apr 29 15:20 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Anybody got Scan Tech heavy-duty coil springs on your wagon? I know I've seen 'em mentioned here, but can't find the posts... and I have questions...

I got a set of these from FCP and installed this weekend. I was expecting that the rear end would be a bit higher, and firmer (ie harder to push down on the bumper). Instead, the rear is lower (26 1/2" vs. 26 3/4", measured at center of rear wheel arch), and seems bouncier when pushing down on the bumper.

Does this match your experience with these springs? I called FCP & they are "researching"... will call them again tomorrow. The springs they sent were labeled with what they said are the correct part # (Volvo #1359710; Scan Tech # 66110)... perhaps the two springs were mislabled? seems unlikely but who knows.

Here's a photo of one of the new springs, next to one of the old ones, which to the best of my knowledge is stock, and original.



TIA,
Brian '93 945T 107,500






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Scan Tech HD wagon springs [900][1993]
posted by  Brian S  on Tue Apr 29 15:20 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.