Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

'bulb failure' light on after installation of trailer towing harness 200 1993

posted by  raidman on  Sun Apr 27 13:43 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

Getting ready to tow a U-haul trailure up to the NE from Texas and have installed a used Drawtite hitch and now obtained the 5 wire to 4 wire towing electrical harness from U Haul. connected it up as per instructions
(1)left and right turn signals,
(2)left(driver's side) taillight,
(3) left(driver's side) brakelight
(4) a ground
Everything works OK except that the bulb failure light turns on whenever I step on the brake, even though both lights shine brightly. What to do?
Should I run an extra wire to the passengers side brakelight?
Or is it time for the black electrical tape over the bulb failure light?
gracias in advance.
el Raidman






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 'bulb failure' light on after installation of trailer towing harness [200][1993]
posted by  raidman  on Sun Apr 27 13:43 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.