Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Is there a default setting- in Ohms- for the mixture control on an AMM for LH 2.0? 200 1983

posted by  Wupwup pull up on  Fri Apr 11 05:56 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am trying to diagnose a persistant idle problem. Is there a recommended steeing for the idle control? The Bentley manual says 1-1000 Ohms. I have overhauled a lot of the intake/fuel injection components. I think it was at 600 Ohms before, but it has no anti-tamper plug and it may have changed. I would like to have it at a conservative setting so I can try to rule it out to find the real culprit.

Thank you






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Is there a default setting- in Ohms- for the mixture control on an AMM for LH 2.0? [200][1983]
posted by  Wupwup pull up  on Fri Apr 11 05:56 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.