Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel injection line (hard plastic) 200

posted by  Bruce S. on  Wed Apr 9 07:56 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 19:05 CST 2014
[RELATED]

Hello all, I need to remove a fuel line from the barbed end of a check valve and reuse it. I remember someone here saying you can do this with a heatgun. Do I just heat it up, remove the old valve, keep it hot and install the new valve? Is this stuff O.K. to reuse, and does it form a good seal? Also is this stuff available somewhere, I've oftened wonder what I would do if I screwed one up.

Thanks,
--
Bruce S. near D.C.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel injection line (hard plastic) [200]
posted by  Bruce S. subscriber  on Wed Apr 9 07:56 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.