Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2008 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

current draw on door lock switch...common someone must know... 900

posted by  the kick inside on  Mon Apr 7 09:08 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 17 09:58 CST 2007
[RELATED]

Ok as my current alarm system has blown up so no more remote central locking I need to replace it....

I didnt install the old system, but I did remove it (its really not hard defeating an engine imobaliser..) and have the following left in place...

aftermarket two wire motor in driver door

plan is to wire the aftermarket motor in parrallel into the original motors, then connect the negative outputs fro mthe new alarm to the key switch return wires, thus havign the new alarm 'simulate' the key switch being operated...

the new alarm has a maximum output of 300ma on these connections..anyone know what the relay draws?

if its more than 300ma then I will put extra relays in place to switch the current, but I hate to do that if I dont need too...





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New current draw on door lock switch...common someone must know... [900]
posted by  the kick inside  on Mon Apr 7 09:08 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.