Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

More on re-using fasteners 200

uid 2796's pic
posted by  bulletproof on  Mon Apr 7 03:51 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:02 CST 2014
[RELATED]

I should have asked about this in yesterday's question about bushings.
Not long ago someone asked about re-using the front caliper bolts. Okay so what about rear suspension fasteners (I'm replacing rear bushings)? Bentley says replace the locking nuts (sounds like a good idea). They do not give sizes or thread. From memory, there four M14's for the trailing arms, twelve M12's for shocks/sway bar torque rods and track rod and two M10's for the spring seats.
Is this correct?
Should I replace them or use the old ones? If so, what material are they made of? And are these coarse or fine thread?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New More on re-using fasteners [200]
posted by  bulletproof subscriber  on Mon Apr 7 03:51 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.