Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need Help Testing an '83 240 Air Mass Meter 200 1983

posted by  Wupwup pull up on  Tue Mar 25 12:07 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am testing my AMM according to the Bentley book in trying to solve a poor idle, and now a no start condition.

I tested the Platinum wire resistance and it tested high-4.6 to 5.1, Bentley says allowable range is 3.5-4.0. Do I have a bad AMM? Also would it help to spray Intake cleaner over the assembley inside it? I also checked the Idle Mixture Potentiometer- it tested at 842 OHMS. The plug is missing- I have left it where it was, but could this be the source of my problems?

Thank You for your time,
Seth Johnson at the University of North Dakota






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need Help Testing an '83 240 Air Mass Meter [200][1983]
posted by  Wupwup pull up  on Tue Mar 25 12:07 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.