Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Trailing Arm Bushings 200 1983

posted by  someone claiming to be Skip on  Thu Mar 20 06:05 CST 2003 [RELATED]

Last night I had my first opportunity to use the Volvo Bushing Tool I picked up on ebay a few years ago. To my surprise, the "sleeve" into which the old bushing is to be pulled is too small to fit around the end of the bushing. The new bushing slides easily through the sleeve. As far as I know, there is only one size for the large bushing. The tool is the actual Volvo tool and the part number on the tool matches the factory manual which I am also using. Should be an easy job but??? Which direction should the taper on the bushing be pointed (in or out)? It seems to be pointing out on the one in the car (original or old replacement). Opinions? Thanks.

Skip
'93 850GLT
'89 765T
'83 242TI Flathood






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Trailing Arm Bushings [200][1983]
posted by  someone claiming to be Skip  on Thu Mar 20 06:05 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.