Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Indexing the drive plate for B230 engines with LH 2.4 Jetronic

uid 55's pic
posted by  john sargent on  Mon Dec 30 15:31 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

There have been many questions about indexing the drive plate on LH 2.4 equipped B230 engines. The RPM sensor gets its signal from a slotted wheel riveted to the drive plate. For LH engines there are 58 slots with room for 60 slots, there being two hole voids. With the engine on number one cylinder TDC, the hole void should be just at the bottom of the starter opening.

In addition there is an arrow on the front of the drive plate which should point at the RPM sensor.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Indexing the drive plate for B230 engines with LH 2.4 Jetronic
posted by  john sargent subscriber  on Mon Dec 30 15:31 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.