Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Voltage,OD,Oil Sender,Thermistat ?'s 200 90

Good Morning Bricksters.(Esp.Don,Abe,SteveR.,MittenHead)

1. I have a unit that draws 3 volts. What to place between +12V battery and unit to get constant +3V (resistors,rheostat,12MegaJoule Cyclatron..).RadioShack wants $22 for cig lighter plug-in.

2. AW70 Xmission.Need to service OD solenoid. Would a 12mm "crows foot"wrench work.Seems better/easier than putting 2 90deg. bends in a long 12mm wrench handle.

3. How many threaded holes in block with access to oil.Want to put oil pressure sender in and keep idiot light operable.Can't find T-adaptor(even at www.autometer.com).

4. Replaced thermistat.1st time.Getting reading from temp gauge for 10-15 minutes,then slowly drops to 0 reading. [A] Think of thermistat shape as kid's top.Does bottom of top go toward block?Bentley no help. [B] Need access to temp comp. board. Trouble seperating inst. cluster housing + green circuit board. Also,are seperate components testable/replaceable? Where best ($) to find new TC Board? TIA






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Voltage,OD,Oil Sender,Thermistat ?'s [200][90]
posted by  someone claiming to be Matt McGonegle  on Sat Dec 9 05:49 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.