Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2020 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1985 740 GLE non turbo R & R 700 1985

posted by  someone claiming to be john chiodi on  Mon May 21 02:07 CST 2001 [RELATED]

I just removed intake manifold in preparation of redoing wiring harness.

(I've been cleaning off oil deposits for past two days!) I may as well clean and replace everything I can while I've got it opened up. So...

On the oil separator? below flame trap, I've seen remarks regarding NOT disturbing the hose into the oil pan. Is it connected to the oil separator?

How difficult to remove without disturbing this?

Also I see two sensors screwed into the block, one with one wire to it is the oil temp gauge to instrument gauge? the other to the ECU? with a plug with several wires. Should I replace them both, can I check without running engine? Any thing else I should replace check while I have excess?

I plan on replacing vacuum lines, heater hoses, etc.

Another question. When I removed fuel line from rail it would not stop leaking. I even put it above the level of gas tank. Is this normal.

What about cleaning intake manifold while off? Sorry for all the questions but I don't want to have to do this again this decade!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1985 740 GLE non turbo R &amp; R [700][1985]
posted by  someone claiming to be john chiodi  on Mon May 21 02:07 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.