Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AMM Update - Replace or Live with it? 200 1989

I posted a message about a week or two ago concerning my AMM. Specifically, when I start it after it sits for hours, it will idle for a second or two and then stall out. It takes about 3 starts to get it going, and then it's fine for the rest of the day (until it sits again).

This morning, I disconnected the AMM. It started right up, with no signs of wanting to stall. I put my automatic into Reverse, and again, no signs of stalling like it usually does when it sits.

It doesn't stall at lights, and its initially fine once it gets going. My question, should I live with it or replace it? My mechanic quoted me $188 for a new Bosch one, if I remember correctly - that's his price. So, I may be looking at around $215-$225?

Will it get much worse off if I leave it? Or is that too hard to tell?

Thanks!

Eric

'89 244dl 113k auto






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM Update - Replace or Live with it? [200][1989]
posted by  someone claiming to be Eric  on Mon May 14 14:47 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.