Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

k-jet mixture adjustment... 200 1980

posted by  someone claiming to be Anthony on  Wed Jan 31 23:43 CST 2001 [RELATED]

OK, here is my problem. I am trying to adjust the mixture on my 242. The hayne's says to attach a dwell meter to the red test lead. With the engine fully warmed and the oxygen sensor disconnected, it reads about 55 degrees. This is higher than it calls for, I believe. The book says to turn the mixture adjustment screw until the dwell meter reads correctly. The dwell meter does not change. The engine will run differently as I turn it, but the dwell meter stays the same. Also, with the O2 sensor connected the dwell meter drops below 30 degrees and pegs the dwell meter. What is going on here? When I first connect it, the reading drops slowly from 55 to below 30 and then stays there.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New k-jet mixture adjustment... [200][1980]
posted by  someone claiming to be Anthony  on Wed Jan 31 23:43 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.