Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rearend clunk/rattle - driveshaft? 200 93

I'm being driven insane by a rattle (not quite a clunk)somewhere from the middle to the back of the car. I was convinced some piece of exhaust was hitting the underside but I have eliminated this possibility. Sound occures usually at low speeds going over even the tinniest of bumps. At higher speeds (40+ mph) I don't hear it.

I noticed yesterday when I grab the driveshaft at the center support bearing and push up and down or right to left, the support bearing moves around inside its bracket oh about 1/16 inch and seems like that could definitely be causing my noise. The bearing to driveshaft interface is tight with no clearance that I can detect. Sound could be coming from that vicinity which is about where rear passenbers feet would be.

Any opinions or experiences appreciated. I don't see how whatever holds the center support bearing on the outside could be a wear item.

Thanks in advance,

Robb






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rearend clunk/rattle - driveshaft? [200][93]
posted by  someone claiming to be robb, formerly rbm  on Tue Nov 21 04:14 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.