Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Brake Booster Adjustment 200 1981

posted by  81242DLB21FCA on  Sun Sep 10 10:14 CST 2023
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 22:26 CST 2014
[RELATED]

I'm in the process of replacing the vacuum brake booster in my '81 242DL B21F. The shaft that sticks out of the front of the booster and goes into the back of the master cylinder is suppose to be adjustable in length. So far I've been unable to turn the little nut on the end of the shaft to set the length to specification.

The instructions say there should be 0.020" - 0.030" clearance between the end of the booster shaft and the back of the master cylinder piston. This is to allow the springs in the master cylinder to completely retract the master cylinder piston when your foot is off the brake peddle.

IPD has this video about it: https://www.youtube.com/watch?v=Tde6xd8ezr4

Any advice please.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake Booster Adjustment [200][1981]
posted by  81242DLB21FCA  on Sun Sep 10 10:14 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.