Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2013 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

inner ball joints 1993 940 with Koyo rack 900 1993

posted by  B.B. on  Thu Jul 29 11:57 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 6 13:15 CST 2014
[RELATED]

Beck/Arnley inner ball joints for the Koyo rack arrived today.
The major difference is ball ends have different threads and different clip washers.

I don't have the shop manual and have unanswered questions:

What's the best way to get the metal boot clamps off without damaging the boot?
Is there a tool to remove and re-install the metal clamps? Reassembly with metal clamps or use tie wraps, what's best?

How do the washers install, do the tabs fit in holes in the rack ?
I don't see whats going on with those tabbed washers.

The balls have grease, should I put a little never-seez on the threads?

Any other lube or details before reassembly?

Thanks, Bill





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New inner ball joints 1993 940 with Koyo rack [900][1993]
posted by  B.B. subscriber  on Thu Jul 29 11:57 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.