Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B230FT Cylinder Head Oil Leak 900

posted by  Townshend Act on  Mon Mar 8 20:52 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 7 22:44 CST 2014
[RELATED]

Hi Everyone,

I'm trying to correct an engine oil seepage coming from the small Allen head plug at the rear of the cylinder head, under the distributor housing. The plug is used to close off the oil galley servicing passage at the rear of the cylinder head.

I put UV Dye in the engine oil and properly pinpointed the source of the leak, so there is no question there. It is NOT the valve cover gasket or distributor housing o-rings.

The Allen head plug and cylinder head threads appear in good condition (not stripped or cross-threaded), but every sealant I've used has failed.

Question: What can I use to seal this oil galley plug to end the leaking?

I've tried Permatex RTV, Three-Bond, Epoxy, JB Weld, and the last time I used RectorSeal 5.

I'm now seriously considering cylinder head removal and having the machine shop weld it closed.

The engine has been rebuilt recently and runs tip-top. It just drips that small amount of oil.

Any help appreciated as always!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B230FT Cylinder Head Oil Leak [900]
posted by  Townshend Act subscriber  on Mon Mar 8 20:52 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.