Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine/Transmission installation 1800

posted by  PBL1 on  Sat Feb 20 16:47 CST 2021
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello folks, anyone have advise on engine installation with transmission mounted to cross member/ suspension and installing from bottom up as I would assume factory did. I am fortunate to have a two post lift as well as a heavy duty rolling table to use. Wondering if this makes sense to go this way or more conventional from top down to mate to installed cross frame. I was successful in removing engine and transmission in one piece from top several years back when I started this restoration so can repeat that process just thinking it might be safer from bottom up.

Thank you for any advise/recommendations you have,
Peter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine/Transmission installation [1800]
posted by  PBL1  on Sat Feb 20 16:47 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.